Dell PowerConnect 6024 - Assigning SNMP User Security

Configuring System Information 207
The following is an example of the CLI commands:
Console (config)# snmp-server group user-group v3 priv read user-
view
Assigning SNMP User Security
The SNMPv3 User Security Model (USM) page enables assigning system users to SNMP groups,
as well as, defining the user authentication method.
To open the
SNMPv3 User Security Model (USM) page , click System → SNMP → User Security
Model
in the tree view .
Table 6-41. SNMP Access Control CLI Commands
CLI Command Description
snmp-server group
groupname {v1 | v2 |
v3 {noauth | auth |
priv}} [read
readview ] [write
writeview ] [notify
notifyview ]
Configure a new Simple Network Management
Protocol (SNMP) group, or a table that maps
SNMP users to SNMP views.
show snmp groups
[
groupname ]
Displays the configuration of groups