Configuring Switch Information 305
The following is an example of the CLI commands:
Console (config-if)# switchport mode access
Console (config-if)# switchport trunk native vlan 123
Console (config-if)# switchport general pvid 234
Console (config-if)# switchport general allowed vlan add 1,2,5,6
tagged
Console (config-if)# switchport general acceptable-frame-type
tagged-only
Defining VLAN Protocol Groups
The
Protocol Group
page contains information regarding protocol names and the VLAN Ethernet
type. Interfaces can be classified as a specific protocol based interface. The classification places the
interface into a protocol group.To open the
Protocol Group
page, click
Switch
→
VLAN
→
Protocol
Group
in the tree view.
Figure 7-31. Protocol Group Table
Frame Type
— The packet type. Possible field values are
Ethernet
,
RFC1042
, and
LLC Other
.
Protocol Value
— User-defined protocol name.
Ethernet-Based Protocol Value
— The Ethernet protocol group type.
Protocol Group ID
— The VLAN Group ID number.
To Next Page
Loading...
