Dell PowerConnect 6024 - Defining Qos UDP to Queue Mapping

Configuring Quality of Service 443
Removing TCP to Queue Mapping
1 Open the QoS TCP to Queue page.
2 Click Show All to display the TCP to Queue Mapping Table page.
3 Check the Remove check box for each of the TCP ports for which queue mapping is removed.
4 Click Apply Changes .
Defining TCP to Queue Mapping Using the CLI Commands
The following is an example of the CLI commands:
console(config)# qos map tcp-port-queue 2000 80 to 2
console(config)# exit
console# show qos map tcp-port-queue
Tcp port - queue map
Port queue
--------------------
6000 1
6001 2
6002 3
Defining QoS UDP to Queue Mapping
The QoS UDP to Queue page enables mapping of a UDP port to a queue. To open the page, click
Quality of Service → QoS Global Parameters → UDP to Queue in the tree view.
Table 10-7. TCP to Queue Mapping CLI Commands
CLI Command Description
qos map tcp-port-
queue
port1 ... port
8 to queue-id
Modifies the TCP-Port to queue.
show qos map [dscp-
queue | tcp-port-
queue | udp-port-
queue | dscp-policed
| dscp-mutation]
Displays all the QoS maps.