Configuring the Switch 79
Figure 5-2. HyperTerminal Properties Window
NOTE: 115,200 is the default baud rate for new device. The device may have another baud rate. If using
the 115,200 baud rate does not result in viewing the device terminal, try other baud rate.
3
Use an F2F null modem cable to connect the workstation to the switch.
4
Connect the device power cord and power up the device.
The following screen is displayed:
**************************************************
***************** SYSTEM RESET *****************
**************************************************
Booting...
Boot1 Checksum Test...............................PASS
Boot2 Checksum Test...............................PASS
Flash Image Validation Test.......................PASS
To Next Page
Loading...
