Dell PowerConnect 6024 - Page 120

130 Configuring System Information
www.dell.com | support.dell.com
The TACACS+ Table page opens.
3 Select a TACACS+ Table entry.
4 Select the Remove check box.
5 Click Apply Changes .
The TACACS+ server is removed, and the device is updated.
Defining TACACS+ Servers Using CLI Commands
The following table summarizes the CLI commands for working with fields in the OOB
TACACS+ Settings
page.
Table 6-12. Out-of-Band TACACS+ Settings CLI Commands
CLI Command Description
tacacs-server host {oob/ip-address |
hostname} [single-connection] [port
port-number] [timeout timeout] [key
key-string] [source source] [priority
priority]
Specifies a TACACS+ server host.
no tacacs-server host {ip-address |
hostname}
Deletes a specified TACACS+ server host.
tacacs-server key [
key-
string
]
Specifies the authentication and encryption
key used for all TACAS communication
between the device and the TACACS+ server.
This key must match the encryption used on
the TACACS daemon. (Range:0-128
characters)
no tacacs-server key Returns to the default.
tacacs-server timeout
timeout
Specifies the timeout value in seconds.
(Range: 1-30)
no tacacs-server timeout Returns to the default.
tacacs-server source-ip
oob/ip-address
Specifies the source IP address. (Range:
Valid IP address)
no tacacs-server source-ip
oob/ip-address
Returns to the default.
show tacacs [oob/ip-address] Displays configuration and statistics for a
TACACS+ server.