Dell PowerConnect 6024 - Page 135

Configuring System Information 145
Remove — When checked, removes the interface from the IP Address drop-down menu.
Adding an IP Interface
1 Open the IP Interface Parameters page.
2 Click Add to open the Add a Static IP Interface page.
Figure 6-25. Add a Static IP Interface
3
Complete the fields on the page.
Network Mask specifies the subnetwork mask of the source IP address.
Each part of the IP address must start with a number other than zero. For example, IP addresses
001.100.192.6 and 192.001.10.3 are invalid.
4
Click Apply Changes .
The new interface is added, and the device is updated.
Modifying IP Address Parameters
1 Open the IP Interface Parameters page.
2 Select an IP address in the IP Address drop-down menu.
3 Modify the required fields.
4 Click Apply Changes .
The parameters are modified, and the device is updated.
Deleting IP Addresses
1 Open the IP Interface Parameters page.
2 Click Show All to display the Interface Parameters Table page.
3 Select an IP address and check the Remove check box.
4 Click Apply Changes .
The IP address is deleted, and the device is updated.