Dell PowerConnect 6024 - Page 159

Configuring System Information 169
Figure 6-40. Optical Transceiver Diagnostics
The Optical Transceiver Diagnostics page contains the following fields:
Port — The port IP address on which the cable is tested.
Temperature — The temperature (C) at which the cable is operating.
Voltage — The voltage at which the cable is operating.
Current — The current at which the cable is operating.
Output Power — The rate at which the output power is transmitted.
Input Power — The rate at which the input power is transmitted.
Transmitter Fault — Indicates if a fault occurred during transmission.
Loss of Signal —Indicates if a signal loss occurred in the cable.
Data Ready —Indicates the transceiver has achieved power up and data is ready.
Displaying Optical Transceiver Diagnostics Test Results Table
1 Open the Optical Transceiver Diagnostics page.
2 Click Show All to run the test and open the Virtual Cable Test Results Table page.