Dell PowerConnect 6024 - Page 186

196 Configuring System Information
www.dell.com | support.dell.com
Modifying the RADIUS Server settings
1 Open the RADIUS Settings page.
2 Click Show All to display the RADIUS Servers List .
3 Modify the fields in the dialog.
4 Click Apply Changes .
The RADIUS Server settings are modified, and the device is updated.
Deleting a RADIUS Server for the RADIUS Servers List
1 Open the RADIUS Settings page.
2 Click Show All to display the RADIUS Servers List .
3 Select a RADIUS Server and check the Remove check box.
The RADIUS server is removed from the list
.
Defining RADIUS Servers Using CLI Commands
The following table summarizes the equivalent CLI commands for defining fields displayed on the
RADIUS Settings
page.
Table 6-38. RADIUS Server CLI Commands
CLI Command Description
radius-server timeout
timeout
Sets the interval for which a router waits for a
server host to reply.
radius-server
retransmit
retries
Specifies the number of times the software
searches the list of RADIUS server hosts.
radius-server deadtime
deadtime
Configures unavailable servers to be skipped.
radius-server key
key-
string
Sets the authentication and encryption key for
all RADIUS communications between the
router and the RADIUS environment.
radius-server host
ip-
address
[auth-port
auth-port-number ]
[timeout timeout]
[retransmit
retries ]
[deadtime
deadtime ]
[key
key-string ]
[source
source ]
[priority
priority ]
Specifies a RADIUS server host.
show radius-servers Displays the RADIUS server settings.