Configuring System Information 229
Figure 6-72. Copy Files
The
Copy Files
page contains the following fields:
Copy Configuration
— Specifies that a configuration file should be copied.
Source
— The configuration source file (running, startup, backup) from which the file is copied.
Destination
— The destination configuration file (running, startup, backup) to which the file is
copied.
Restore Configuration Factory Defaults
— When checked, specifies that the factory configuration
default files should be reset. Unchecked maintains the current configuration settings.
NOTE: Copying files to the running configuration file only adds configuration data; it does not replace the
file.
Copying Files
1
Open the
Copy Files
page
.
2
Select
Copy
or
Restore
, and complete the fields.
3
Click
Apply Changes
.
The file is copied.
Copying Files Using CLI Commands
The following table summarizes the equivalent CLI commands for defining fields displayed in the
Copy Files
page.
To Next Page
Loading...
