254 Configuring Switch Information
www.dell.com | support.dell.com
Figure 7-12. ACL Bindings
The
ACL Bindings
page contains the following fields:
Select an ACL
ā The ACL type to which incoming packets are matched. Packets can be matched
to either IP based ACLs or MAC Address based ACLs.
Bind ACL to Interface
ā The interface and interface type to which the ACL is attached. You can
attach the ACL to a port, LAG, or VLAN.
Assigning an ACL to an Interface
1
Open the
ACL Bindings
page.
2
Select the ACL type in the
Select ACL
field.
3
Select the interface to which the ACL is attached in the
Bind ACL to an Interface
field.
NOTE: Whenever an ACL is assigned on a port, LAG or, VLAN, flows from that ingress interface that do
not match the ACL are matched to the default rule, which is Drop unmatched packets.
4
Click
Apply Changes
.
The ACL is attached to the interface.
Removing an Entry from the ACL Bindings Table
1
Open the
ACL Bindings
page.
2
Click
Show All
to display the
ACL Bindings Table
.
3
Check the
Remove
check box for the entry that you want to remove.
To Next Page
Loading...
