Dell PowerConnect 6024 - Page 311

Configuring Switch Information 321
Adding Bridge Multicast Addresses
1 Open the Bridge Multicast Group page.
2 Click Add to display the Add Bridge Multicast Group page.
Figure 7-38. Add Bridge Multicast Group Page
3
Define the VLAN ID and New Bridge Multicast Address fields.
4 Toggle a port to S to join the port to the selected multicast group.
5 Toggle a port to F to forbid adding specific multicast addresses to a specific port.
6 Click Apply Changes .
The bridge multicast address is assigned to the multicast group, and the device is updated.
Defining Ports to Receive Multicast Service
1 Open the Bridge Multicast Group page.
2 Define the VLAN ID and the Bridge Multicast Address fields.
3 Toggle a port to S to join the port to the selected multicast group.
4 Toggle a port to F to forbid adding specific multicast addresses to a specific port.
5 Click Apply Changes .
The port is assigned to the multicast group, and the device is updated.
Blank Indicates that the port is not attached to a
Multicast group.
Table 7-32. IGMP Port/LAG Members Table Control Settings
Port Control Definition