Dell PowerConnect 6024 - Page 328

338 Configuring Routing
www.dell.com | support.dell.com
3 Define the fields.
See "Configuring VRRP" for information about the fields.
NOTE: VRRP interfaces must be defined before the admin state can be Enabled.
4
Click Apply Changes .
The new VRRP interface is added, and the device is updated.
NOTE: If an illegal virtual IP address is entered, a warning will display, but the virtual router will be
added. It is recommended that you delete this entry from the virtual routers table.
Modifying VRRP Routers
1 Open the Virtual Router Redundancy Protocol (VRRP) page .
2 Select an interface in the Interface field.
3 Define the fields as desired.
4 Click Apply Changes .
Deleting a VRRP Entry
1 Open the Virtual Router Redundancy Protocol (VRRP) page .
2 Click Show All to display the VRRP Table .
3 Select a table entry.
4 Check the Remove check box.
5 Click Apply Changes .
The VRRP entry is deleted, and the device is updated.
Configuring VRRP Using the CLI Commands
The following table contains the CLI commands for configuring the VRRP.
Table 8-3. VRRP CLI Commands
CLI Command Description
vrrp
virtual-router ip
ip-address
[ ip-
address2…ip-address8
]
Defines Virtual Router Redundancy Protocol
(VRRP) for an interface.
vrrp
virtual-router up Activates Virtual Router Redundancy Protocol
(VRRP) on an interface.
vrrp
virtual-router
timer
seconds
Configures the time interval between sending
advertisements messages.
vrrp
virtual-router
priority
priority
Configures Virtual Router Redundancy
Protocol (VRRP) priority on an interface.