Dell PowerConnect 6024 - Page 340

350 Configuring Routing
www.dell.com | support.dell.com
Default Route Metric (1-16) — The default route entry metric in RIP updates originating on this
interface. Zero indicates that no default route is originated.
Virtual Distance (1-16) — Virtual number of hops assigned to the interface. This fine-tunes the
RIP routing algorithm.
Authentication Mode — The interface authentication type, Password or MD5, used to
authenticate RIP ver. 2 messages.
Authentication Password — The authentication password.
Authentication Key-Chain — The authentication key chain .
Remove — When checked, removes the RIP interface.
Adding a RIP Interface
1 Open the RIP Interface Parameters page.
2 Click Add to display the New RIP Interface page.
3 Complete the fields on the page.
The fields on this page are the same as those on the
RIP Interface Parameters page.
4 Click Apply Changes .
Modifying RIP Interface Parameters
1 Open the RIP Interface Parameters page.
2 Modify the fields as desired.
3 Click Apply Changes .
The RIP interface parameters are modified, and the device is updated.
Deleting a RIP Interface
1 Open the RIP Interface Parameters page.
2 Use the RIP Interface drop-down menu to select an RIP interface.
3 Check the Remove check box.
4 Click Apply Changes .
The RIP interface is removed and the device is updated.