376 Configuring Routing
www.dell.com | support.dell.com
Figure 8-22. IGMP Dynamic Group Table
Interface
— Specifies an interface belonging to the IP Multicast Group.
Multicast Group Address
— The IGMP multicast IP address.
Group Up Time
— Indicates in ticks the amount of time that has passed since the entry was
created. The time format is hour/minute/second.
Group Expiry Time
—Amount of time before the dynamic entry is aged out. The time format is
hour/minute/second.
Last Reporter
— The last member to join the IP Multicast group. If no member has entered the IP
Multicast group the value is 0.0.0.0.
Viewing IGMP Groups Using CLI Commands
The following table contains the CLI commands for viewing the IGMP groups.
Table 8-18. IGMP Group CLI Commands
CLI Command Description
show ip igmp groups
[
group ip-address
]
[ethernet interface-
number
|
vlan vlan-id
|
port-channel number
]
Displays the Multicast groups with receivers
that are directly connected to the router, and
that were learned through Internet Group
Membership Protocol (IGMP).
To Next Page
Loading...
