Dell PowerConnect 6024 - Page 417

Configuring Quality of Service 427
Selecting a Service Mode
1 Open the QoS Settings page.
2 Select a service mode in the QoS Mode field.
3 Click Apply Changes .
The QoS mode is selected, and the device is updated.
Setting the Default CoS Value for Incoming Traffic on an Interface
1 Open the QoS Settings page.
2 Select an interface, and set the default CoS value for incoming traffic from the drop-down
menu.
3 Click Apply Changes .
The default CoS value for incoming traffic on the interface is selected, and the device is
updated.
Copying QoS Interface Settings
1 Open the QoS Settings page.
2 Click Show All to display the QoS Interface Settings Table page.
3 Select an interface from which to copy QoS settings to all or any of the interfaces listed in the
QoS Interface Settings Table.
4 Check the Copy to check box for each interface to which the QoS settings should be copied,
or click
Select All to copy the QoS settings to all listed interfaces.
5 Click Apply Changes .