438 Configuring Quality of Service
www.dell.com | support.dell.com
The CoS to queues mapping is reset to the default, and the device is updated.
Mapping CoS to Queues Using the CLI Commands
The following table contains the CLI commands for mapping CoS to queues.
The following is an example of the CLI commands:
console(config)# wrr-queue cos-map 7 246
console(config)# show qos map dscp-queue
Dscp-queue map:
d1 : d2 0 1 2 3 4 5 6 7 8 9
--------------------------------------------
0 : 01 01 01 01 01 01 01 01 02 02
1 : 02 02 02 02 02 02 03 03 03 03
2 : 03 03 03 03 04 04 04 04 04 04
3 : 04 04 05 05 05 05 05 05 05 05
4 : 06 06 06 06 06 06 06 06 07 07
5 : 07 07 07 07 07 07 08 08 08 08
6 : 08 08 08 08
console(config)# show qos map tcp-port-queue
Tcp port-queue map:
Port queue
----- ------
6000 1
Table 10-5. Mapping CoS Queues CLI Commands
CLI Command Description
wrr-queue cos-map
queue-id cos1 ...
cos8
Maps assigned CoS values to select one of the
egress queues.
show qos map [dscp-
queue | tcp-port-
queue | udp-port-
queue | dscp-policed
| dscp-mutation]
Displays all the maps for QoS
To Next Page
Loading...
