Dell PowerConnect 6024 - Page 452

462 Configuring Quality of Service
www.dell.com | support.dell.com
Figure 10-18. QoS Policy Binding Page
Interface — Selects an interface.
Attach Policy to Interface — The policy implemented on the interface.
NOTE: A policy map that contains a set or trust policy-map class configuration command, or that has an
ACL classification cannot be attached to an egress interface.
Attaching a Policy to an Interface
1 Open the QoS Policy Binding page.
2 Select an interface type.
Only one policy map per interface per direction is supported. However, the same policy map
can be applied to multiple interfaces and directions.
3 Select the port, LAG, or VLAN number from the appropriate drop-down menu.
4 Select a policy from the Attach Policy to Interface drop-down menu.
5 Click Apply Changes .
The selected policy is implemented on the selected interface, and the device is updated.
Removing Policies from Interfaces
1 Open the QoS Policy Binding page.
2 Click Show All to display the PTI Reference Table page.