Dell PowerConnect 6024 - Page 91

Configuring System Information 101
Defining System Information
1 Open the Asset page.
2 Define the following fields: System Name , System Contact , System Location , and Asset Tag .
3 Click Apply Changes .
The system parameters are applied, and the device is updated.
Initiating a Telnet Session
1 Open the Asset page.
NOTE: The appropriate telnet parameters are set prior to initiating the telnet session. See "Configuring
an Initial Telnet Password" for information.
2
Click Telnet .
Configuring Device Information Using the CLI Commands
The following table summarizes the equivalent CLI commands for viewing fields displayed in the
Asset
page.
Table 6-1. Asset CLI Commands
CLI Command Description
hostname name Specifies or modifies the device host name.
snmp-server contact
text
Sets up a system contact.
snmp-server location
text
Specifies information about where the device is
located.
show clock Displays the time and date from the system
clock.
asset-tag tag Specifies the asset tag for the device.
show system-id Displays the system ID information, including
service tag, asset tag, and serial number.
show system Displays system information.