Dell PowerConnect 7048P - Page 181

Controlling Management Access 181
Adding and Configuring an Access Profile
To configure an access profile:
1
Open the Access Profile page.
2 Click Add Profile to display the Add an Access Profile page.
3 Enter a name for the Access Profile.
4 Specify a rule for management access, and then click Apply .
In
Figure 9-4 , the Access Profile name is mgmt_ACL, and access is
permitted on VLAN 1 from any host in the 10.27.65.0/24 subnet. Access
on VLAN 1 from a host in any other subnet is denied.
Figure 9-4. Add an Access Profile
5 Click Add Rule .
6 If desired, configure additional access rules to add to the profile, and then
click
Apply .
NOTE: Assigning an access profile to an interface implies that access
through other interfaces is denied.