Table 28. Processor Settings details (continued)
Option Description
Dell Controlled Turbo Settings Controls the turbo engagement. Enable this option only when
System Profile is set to Performance or Custom, and CPU
Power Management is set to Performance. This item can be
selected for each system profile mode. This option is set to
Disabled by default.
NOTE: Depending on the number of installed processors,
there might be up to two processor listings.
Dell AVX Scaling Technology Enables you to configure the Dell AVX scaling technology. This
option is set to 0 by default. Enter the value from 0 to 12
bins. The value that is entered decreases the Dell AVX Scaling
Technology frequency when the Dell-controlled Turbo feature
is enabled.
Optimizer Mode Enables or disables the CPU performance. When this option
is set to Auto, set the CPU Power Management to Max
Performance. When set to Enabled, enables the CPU Power
Management settings. When set to Disabled, the CPU Power
Management option is disabled. This option is set to Auto by
default.
Number of Cores per Processor Controls the number of enabled cores in each processor. This
option is set to All by default.
Processor Core Speed Specifies the maximum core frequency of the processor.
Processor Bus Speed Specifies the bus speed of the processor.
NOTE: The processor bus speed option displays only
when both processors are installed.
Local Machine Check Exception Enables or disables the local machine check exception. This
is an extension of the MCA Recovery mechanism providing
the capability to deliver Uncorrected Recoverable (UCR)
Software Recoverable Action Required (SRAR) errors to
one or more specific logical processors threads receiving
previously poisoned or corrupted data. When enabled, the
UCR SRAR Machine Check Exception is delivered only to the
affected thread rather than broadcast to all threads in the
system. The feature supports operating system recovery for
cases of multiple recoverable faults that are detected close,
which would otherwise result in a fatal machine check event.
The feature is available only on Advanced RAS processors.
This option is set to Disabled by default.
Processor n
NOTE: Depending on the number of processors, there
might be up to n processors listed.
The following settings are displayed for each processor:
Table 29. Processor 1 details
Option Description
Family-Model-Stepping Specifies the family, model, and stepping of the processor as
defined by Intel.
Brand Specifies the brand name.
Level 2 Cache Specifies the total L2 cache.
Level 3 Cache Specifies the total L3 cache.
Number of Cores Specifies the number of cores per processor.
Maximum Memory Capacity Specifies the maximum memory capacity per processor.
36 Pre-operating system management applications
To Next Page