Dell PowerEdge R7625 - BOSS-N1 Module; Removing the BOSS-N1 Module Blank; Installing the BOSS-N1 Module Blank

BOSS-N1 module
Removing the BOSS-N1 module blank
Prerequisites
Follow the safety guidelines listed in the Safety instructions.
Steps
Use a screwdriver to push out the blank from the BOSS-N1 module bay.
Figure 172. Removing the BOSS-N1 module blank
Next steps
1. Replace the BOSS-N1 module blank or install BOSS-N1 module.
Installing the BOSS-N1 module blank
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
Steps
Align the blank with the BOSS-N1 module bay and push it into the bay until it clicks into place.
Installing and removing system components
207