Next steps
1. Replace the BOSS card filler or BOSS-N1 controller card module.
Installing the BOSS card filler
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
Steps
Align the BOSS card filler with the BOSS-N1 controller card module bay and push it into the bay until it clicks into place.
Figure 175. Installing the BOSS card filler
Removing the BOSS-N1 controller card module
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in Before working inside your system.
Steps
1. Pull and lift the BOSS-N1 card carrier retention latch lock to open.
2. Slide the BOSS-N1 card carrier out.
Installing and removing system components
209
To Next Page
Loading...
