Dell PowerEdge R7625 - Removing a 4 X 2.5-Inch Rear Drive Module Cooling Fan; Installing a 4 X 2.5-Inch Rear Drive Module Cooling Fan

Next steps
1. Install the 2 x 2.5-inch rear drive module air shroud.
2. Follow the procedure listed in After working inside your system.
Removing a 4 x 2.5-inch rear drive module cooling fan
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in Before working inside your system.
3. Remove the 4 x 2.5-inch rear drive module air shroud.
Steps
Press the orange release tab and lift the rear drive module cooling fan to disconnect from the connector on the rear drive
module.
WARNING: Ensure not to tilt or rotate the cooling fan while removing from the rear drive module.
Figure 49. Removing a 4 x 2.5-inch rear drive module cooling fan
Next steps
1. Replace 4 x 2.5-inch rear drive module cooling fan.
Installing a 4 x 2.5-inch rear drive module cooling fan
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in Before working inside your system.
3. Remove the 4 x 2.5-inch rear drive module air shroud.
Steps
Align and lower the rear drive module cooling fan into the rear drive module until the fan clicks into place.
Installing and removing system components
89