System overview
The PowerEdge R7625 system is a 2U server that supports:
● Two AMD EPYC 4
th
Generation 9004 series processor with up to 96 cores
● Optional Direct Liquid Cooling (DLC) for required CPUs and/or configurations
● Up to 24 RDIMMs, with up to 3 TB of memory and speeds up to 4800 MT/s
● Two redundant AC or DC power supply units
● Up to 8 x 3.5-inch SATA/SAS drives or 8 x 2.5 SATA/SAS/NVMe or 12 x 3.5-inch SATA/SAS or 16 x 2.5-inch SATA/SAS/
NVMe 24 x 2.5-inch SATA/SAS/NVMe (HDD/SSD) drives
● PCI Express® (PCIe) 5.0 enabled expansion slots
● Network interface technologies to cover Network Interface Card (NIC)
NOTE: For more information about how to hot swap NVMe PCIe SSD U.2 device, see the Dell Express Flash NVMe
PCIe SSD User's Guide at https://www.dell.com/support > Browse all Products > Data Center Infrastructure >
Storage Adapters & Controllers > Dell PowerEdge Express Flash NVMe PCIe SSD > Documentation > Manuals
and Documents.
NOTE: All instances of SAS, SATA drives are referred to as drives in this document, unless specified otherwise.
CAUTION: Do not install GPUs, network cards, or other PCIe devices on your system that are not validated
and tested by Dell. Damage caused by unauthorized and invalidated hardware installation will null and void the
system warranty.
Topics:
• Front view of the system
• Rear view of the system
• Inside the system
• Locating the Express Service Code and Service Tag
• System information label
• Rail sizing and rack compatibility matrix
Front view of the system
Figure 1. Front view of 24 x 2.5-inch drive system
Table 1. Features available on the front of the system
Item Ports, panels, and
slots
Icon Description
1 Left control panel N/A Contains the system health, system ID and the status LED indicator.
2
System overview 9
To Next Page
Loading...
