Dell PowerEdge R7625 - Installing the BOSS-N1 Controller Card Module

Figure 178. Removing the BOSS-N1 controller card module
7. Slide the BOSS-N1 module towards the front of the chassis and lift the module.
Next steps
1. Replace the BOSS-N1 controller card module or Replace the BOSS card filler
Installing the BOSS-N1 controller card module
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
3. If installed, remove the BOSS module blank.
Steps
1. Align the BOSS-N1 module at an angle with the controller card module slot.
2. Insert the BOSS-N1 controller card module and push the module towards the rear of the system until it is secured.
3. Using the Phillips #1 screwdriver, secure the BOSS-N1 controller card module with the M3 x 0.5 x 4.5 mm screw.
4. Connect the BOSS power and signal cable to the connectors on the system board.
Installing and removing system components
211