Dell PowerEdge R7625 - Idrac Quick Sync 2 Indicator Codes

Table 127. System health and system ID indicator codes
System health and system ID
indicator code
Condition
Solid blue Indicates that the system is powered on, is healthy, and system ID mode is not active.
Press the system health and system ID button to switch to system ID mode.
Blinking blue Indicates that the system ID mode is active. Press the system health and system ID
button to switch to system health mode.
Solid amber Indicates that the system is in fail-safe mode.If the problem persists, see the Getting
help section.
Blinking amber Indicates that the system is experiencing a fault. Check the System Event Log
for specific error messages. For information about the event and error messages
generated by the system firmware and agents that monitor system components, go
to qrl.dell.com > Look Up > Error Code, type the error code, and then click Look it
up.
iDRAC Quick Sync 2 indicator codes
iDRAC Quick Sync 2 module (optional) is located on the left control panel of the system.
Table 128. iDRAC Quick Sync 2 indicators and descriptions
iDRAC Quick Sync 2 indicator code Condition Corrective action
Off (default state) Indicates that the iDRAC Quick Sync 2
feature is powered off. Press the iDRAC
Quick Sync 2 button to power on the
iDRAC Quick Sync 2 feature.
If the LED fails to power on, reseat the
left control panel flex cable and check.
If the problem persists, see the Getting
help section.
Solid white Indicates that iDRAC Quick Sync 2 is
ready to communicate. Press the iDRAC
Quick Sync 2 button to power off.
If the LED fails to power off, restart the
system. If the problem persists, see the
Getting help section.
Blinks white rapidly Indicates data transfer activity. If the indicator continues to blink
indefinitely, see the Getting help section.
Blinks white slowly Indicates that firmware update is in
progress.
If the indicator continues to blink
indefinitely, see the Getting help section.
Blinks white five times rapidly and then
powers off
Indicates that the iDRAC Quick Sync 2
feature is disabled.
Check if iDRAC Quick Sync 2 feature
is configured to be disabled by
iDRAC. If the problem persists, see
the Getting help section. www.dell.com/
poweredgemanuals or Dell OpenManage
Server Administrator User’s Guide at
www.dell.com/openmanagemanuals.
Solid amber Indicates that the system is in fail-safe
mode.
Restart the system. If the problem
persists, see the Getting help section.
Blinking amber Indicates that the iDRAC Quick Sync 2
hardware is not responding properly.
Restart the system. If the problem
persists, see the Getting help section.
244 System diagnostics and indicator codes