Dell PowerEdge R7625 - Removing a Power Supply Unit Blank; Installing a Power Supply Unit Blank; Removing a Power Supply Unit Adapter Blank

Removing a power supply unit blank
Prerequisites
Follow the safety guidelines listed in the Safety instructions.
Steps
Pull the blank out of the system.
CAUTION: To ensure proper system cooling, the PSU blank must be installed in the second PSU bay in a
non-redundant configuration. Remove the PSU blank only if you are installing a second PSU.
Next steps
1. Replace the PSU blank or PSU.
Installing a power supply unit blank
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
NOTE: Install the power supply unit (PSU) blank only in the second PSU bay.
2. remove the PSU.
Steps
Align the PSU blank with the PSU bay and push it into the PSU bay until it clicks into place.
Removing a power supply unit adapter blank
Remove the PSU adapter, when installing PSU with 86 mm wide form factor.
Prerequisites
Follow the safety guidelines listed in the Safety instructions.
Steps
Using a Phillips #1 screwdriver, loosen the screw and remove the power supply unit adapter blank.
222
Installing and removing system components