Removing the expansion card risers
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
3.
NOTE: If BOSS N1 module is installed, ensure to disconnect the BOSS N1 power cable and Signal cable before removing
the Riser 1 cage.
Figure 139. Removing the BOSS power cable and BOSS signal cable from the BOSS N1 controller card module
4. Disconnect any cables that are connected to the expansion card.
Steps
1. For Riser 1, loosen the captive screws on the riser.
a. Press the blue release tab and holding the edges lift the expansion card riser from the riser connector on the system
board.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
186 Installing and removing system components
To Next Page
Loading...
