Figure 140. Removing the expansion card riser (Riser 1)
2. For Riser 3, loosen the captive screw, and then press the blue release tab and holding the edges lift the expansion card riser
from the riser connector on the system board.
Figure 141. Removing the expansion card riser (Riser 3)
3. For Riser 2, press the blue button on the riser and holding the touch points (two strips on one side; one strip on the other
side) lift the expansion card riser from the riser connector on the system board.
Installing and removing system components
187
To Next Page
Loading...
