Dell PowerEdge R7625 - Installing a 2 X 2.5-Inch Rear Drive Module Cooling Fan

Figure 47. Removing a 2 x 2.5-inch rear drive module cooling fan
Next steps
1. Replace 2 x 2.5-inch rear drive module cooling fan.
Installing a 2 x 2.5-inch rear drive module cooling fan
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in Before working inside your system.
3. Remove the 2 x 2.5-inch rear drive module air shroud.
Steps
Align and lower the rear drive module cooling fan into the rear drive module until the fan clicks into place.
Figure 48. Installing a 2 x 2.5-inch rear drive module cooling fan
88
Installing and removing system components