Figure 67. Removing the filler bracket for Riser 1A
Figure 68. Removing the filler bracket for Riser 4A
3. For Riser 1A, first pull the black card holder, hold the card by its edges, and align the card edge connector with the expansion
card connector on the riser. Insert the card edge connector firmly into the expansion card connector until the card is fully
seated. Close the metal retention latch. Push the black card holder to hold the card in the riser.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
102 Installing and removing system components
To Next Page
Loading...
