Figure 69. Installing an expansion card into Riser 1A
4. For Riser 4A, first pull the black card holder, hold the card by its edges, and align the card edge connector with the
expansion card connector on the riser. Insert the card edge connector firmly into the expansion card connector until the card
is fully seated. Push the black card holder to hold the card in the riser. Close the metal retention latch.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 70. Installing an expansion card into Riser 1A
Next steps
1. If applicable, connect the cables to the expansion card.
2. Follow the procedure listed in After working inside your system.
3. Install any device drivers required for the card as described in the documentation for the card.
Installing and removing system components
103
To Next Page
Loading...
