Dell PowerEdge XE8640 - Page 42

Table 39. Network Settings details (continued)
Option Description
UEFI HTTP Settings Enables you to control the configuration of the UEFI HTTP device.
HTTP Device n (n = 1 to 4) Enables or disables the device. When enabled, a UEFI HTTP boot option is
created for the device.
HTTP Device n Settings (n = 1 to 4) Enables you to control the configuration of the HTTP device.
UEFI iSCSI Settings Enables you to control the configuration of the iSCSI device.
iSCSI Initiator Name Specifies the name of the iSCSI initiator in IQN format.
iSCSI Device1 Enables or disables the iSCSI device. When disabled, a UEFI boot option
is created for the iSCSI device automatically. This is set to Disabled by
default.
iSCSI Device1 Settings Enables you to control the configuration of the iSCSI device.
UEFI NVMe-oF Settings Enables you to control the configuration of the NVMe-oF devices.
NVMe-oF Enables or disables the NVMe-oF feature. When enabled, it allows to
configure the host and target parameters needed for fabric connection.
This is set to Disabled by default.
NVMe-oF Host NQN This field specifies the name of the NVMe-oF host NQN. Allowed input is
in the following format: nqn.yyyy-mm.<Reserved Domain Name>:<Unique
String>. Leave it empty to use system generated value with following
format: nqn.1988-11.com.dell:<Model name>.<Model number>.<Service
Tag>.
NVMe-oF Host Id This field specifies a 16 bytes value of the NVMe-oF host identifier
that uniquely identifies this host with the controller in the NVM
subsystem. Allowed input is a hexadecimal-encoded string in this format:
00112233-4455-6677-8899-aabbccddeeff. Leave it empty to use system
generated value. A value of all FF is not allowed.
Host Security Key Path This field specifies the Host security key path.
NVMe-oF SubSystem Settings This field controls the parameters for the NVMe-oF subsystem n
connections.
Table 40. PXE Device n Settings details
Option Description
Interface Specifies NIC interface used for the PXE device.
Protocol Specifies Protocol used for PXE device. This option is set to IPv4 or IPv6. This option is set to
IPv4 by default.
Vlan Enables Vlan for PXE device. This option is set to Enabled or Disabled. This option is set to
Disabled by default.
Vlan ID Shows the Vlan ID for the PXE device
Vlan Priority Shows the Vlan Priority for the PXE device.
Table 41. HTTP Device n Settings details
Option Description
Interface Specifies NIC interface used for the HTTP device.
Protocol Specifies Protocol used for HTTP device. This option is set to IPv4 or IPv6. This option is set
to IPv4 by default.
Vlan Enables Vlan for HTTP device. This option is set to Enable or Disable. This option is set to
Disable by default.
Vlan ID Shows the Vlan ID for the HTTP device
42 Pre-operating system management applications