Option Description
• Weekdays
• Select Days
Default setting: Disabled
Deep Sleep
Control
Allows you to aggressive the system is at conserving power while Shut down (S5) or in Hybernate (S4) mode.
• Disabled
• Enabled in S5 only
• Enabled in S4 and S5 (default)
USB Wake
Support
Allows you to enable USB devices to wake the system from Standby.
• Enable USB Wake Support
Default setting: The option is enabled..
Wake on LAN/
WLAN
Allows you to enable or disable the feature that powers on the computer from the Off state when triggered by a
LAN signal.
• Disabled: This option is enabled by default.
• LAN Only
• WLAN Only
• LAN or WLAN
• LAN with PXE Boot
Block Sleep This option lets you block entering to sleep (S3 state) in operating system environment.
Block Sleep (S3 state)
Default setting: This option is disabled
POST Behavior screen options
Option
Description
Numlock LED This option specifies whether the NumLock LED should be on when the system boots.
• Enable Numlock LED: The option is enabled.
Keyboard Errors This option option specifies whether the keyboard related errors are reported when it boots.
• Enables Keyboard Error Detection: The option is enabled by default.
Fastboot Allows you to speed up the boot process by bypassing some of the compatibility steps. The options are:
• Minimal
• Thorough (default)
• Auto
Extend BIOS
POST Time
This option created an additional pre-boot delay.
• 0 seconds (default)
• 5 seconds
• 10 seconds
Full Screen Logo . This option displays full screen logo if your image match screen resolution. The option Enable Full Screen Logo is
not selected by default.
Warnings and
Errors
• Prompt on Warnings and Errors (default)
• Continue on Warnings
• Continue on Warnings and Errors
System setup 63
To Next Page
Loading...
Need help?
General