Delta AH500 - Page 731

AH500 Programming Manual
7-12
Error code Description
CPU
Status
LED indicator
status
ERROR
BUS
FAULT
16#860F
System restoration error
Continue
Blinking
Blinking
16#8611
No memory card exists, or the memory card
format is incorrect.
Continue Keep Keep
16#8612
An error occurs when data is accessed from
the memory card, or the memory card is in
read-only mode.
Continue Keep Keep
16#9A01
The setting of the data exchange for slave 1 in
the PLC Link / COM1 MODBUS is incorrect.
(SM1590)
Continue
Keep Keep
16#9A02
The setting of the data exchange for slave 2 in
the PLC Link / COM1 MODBUS is incorrect.
(SM1590)
Continue
Keep Keep
16#9A03
The setting of the data exchange for slave 3 in
the PLC Link / COM1 MODBUS is incorrect.
(SM1590)
Continue
Keep Keep
16#9A04
The setting of the data exchange for slave 4 in
the PLC Link / COM1 MODBUS is incorrect.
(SM1590)
Continue
Keep Keep
16#9A05
The setting of the data exchange for slave 5 in
the PLC Link / COM1 MODBUS is incorrect.
(SM1590)
Continue
Keep Keep
16#9A06
The setting of the data exchange for slave 6 in
the PLC Link / COM1 MODBUS is incorrect.
(SM1590)
Continue
Keep Keep
16#9A07
The setting of the data exchange for slave 7 in
the PLC Link / COM1 MODBUS is incorrect.
(SM1590)
Continue
Keep Keep
16#9A08
The setting of the data exchange for slave 8 in
the PLC Link / COM1 MODBUS is incorrect.
(SM1590)
Continue
Keep Keep
16#9A09
The setting of the data exchange for slave 9 in
the PLC Link / COM1 MODBUS is incorrect.
(SM1590)
Continue
Keep Keep
16#9A0A
The setting of the data exchange for slave 10
in the PLC Link / COM1 MODBUS is incorrect.
(SM1590)
Continue
Keep Keep
16#9A0B
The setting of the data exchange for slave 11
in the PLC Link / COM1 MODBUS is incorrect.
(SM1590)
Continue
Keep Keep
16#9A0C
The setting of the data exchange for slave 12
in the PLC Link / COM1 MODBUS is incorrect.
(SM1590)
Continue
Keep Keep
16#9A0D
The setting of the data exchange for slave 13
in the PLC Link / COM1 MODBUS is incorrect.
(SM1590)
Continue
Keep Keep
16#9A0E
The setting of the data exchange for slave 14
in the PLC Link / COM1 MODBUS is incorrect.
(SM1590)
Continue
Keep Keep
16#9A0F
The setting of the data exchange for slave 15
in the PLC Link / COM1 MODBUS is incorrect.
(SM1590)
Continue
Keep Keep