Chapter 5 Configuring in DIADesigner-AX
5-5
After that, ASRTU-EC16AP1TA is visible in the EtherCAT configuration as the following figure shows.
Close the window after adding ASRTU-EC16AP1TA is finished.
3. Right-click ASRTU-EC16AP1TA and then click “Add Device…” from the pop-up menu.
Then the “Add Device” window is open, where ASRTU-EC16AP1TA’s right-side extension modules are added.
Select corresponding modules one by one according to the actual connection order of the extension modules
and click “Add Device” button to add them.
To Next Page
Loading...
