ASRTU-EC16AP1TA EtherCAT Remote Communication Module Operation Manual
B-2
B.1 Online Firmware Upgrade
ASRTU-EC16AP1TA’s V1.0 and above firmware supports the online upgrade. Relevant operation steps are
as follows, taking AX-308E for example.
1. Open the DIADesigner-AX software page, create a new project and then add ASRTU-EC16AP1TA to the
EtherCAT network, as shown in the following figure:
Note: Please refer to Section 5.2 for details on how to add ASRTU-EC16AP1TA to the EtherCAT network.
2. With a double click on "EtherCAT_Master_SoftMotion", open the EtherCAT master configuration interface
and then deselect "Automatic restart slaves" option in the "General" tab.
3. Click the "Login" option on the "Online" menu of the menu bar.
To Next Page
Loading...
