Delta PCS100HV - Page 76

OPERATION MANUAL FOR PCS100HV
76
Note: The user can enable or disable one or more protection items by setting bitx of register[0x0618] to “1” or “0”.
8.2.4. Auto Recharging Control mode
When the SOC is lower than the set lower limit [0x061F], if the auto-recharging function is enabled through setting the register [0x0618] (bit8=1, bit9=1),
the PCS100HV will automatically start recharging according to the power command set by the register [0x0621].
STEP
CMD
DESCRIPTION
REMARK
Option
ID(PCS)
Function
Register
Value
CRC REF
1
01
06
0618
0FFF
4C F5
BMS Auxiliary Configuration Enable Registers
bitx = 1: Check enable,
bitx = 0: Check disable; x=0-15
b8=1: Battery Auto Recharge by SOC Enable.
b9=1: Battery Auto Recharge Power by Set
Enable.
Enable auto-recharging
function of Battery system
*Note: All protection functions
and power limit function are
enabled.
[M]
2
01
06
061F
0019
79 4E
Start charging when SOC is less than 2.5%.
SOC low limit= 2.5%
[O]
3
01
06
0620
0064
89 63
Stop charging when SOC is greater than 10%.
SOC high limit= 10%
[O]
4
01
06
0621
00C8
D8 DE
Power command for auto-charging
Power Command = 20kW
[M]
8.2.5. Manual Recharging Control mode
When the SOC is lower than the set lower limit [0x061F], if the manual-recharging function is enabled through setting the register [0x0618] (bit8=1,