SERVICE MANUAL
Contents
(Rev. 0) RTG PLUS (120V)
i
Contents
1. INTRODUCTION 1-1
1.1 Icons appearing in the manual ............................................................ 1-1
2. SAFETY INFORMATION 2-1
2.1 Warnings ............................................................................................. 2-2
2.2 Environmental risk and disposal ......................................................... 2-3
2.3 Symbols used ...................................................................................... 2-4
3. DESCRIPTION 3-1
3.1 Identification labels ............................................................................. 3-1
3.2 Description .......................................................................................... 3-3
4. TECHNICAL FEATURES 4-1
4.1 Standards and regulation .................................................................... 4-4
4.2 X-ray tubehead curves ........................................................................ 4-5
4.2.1 Tube "CEI - OPX/105" (0.5x0.5)........................................................4-5
4.3 Technical factors measuring method ................................................... 4-7
4.4 Overall dimension................................................................................ 4-8
5. PRE-INSTALLATION 5-1
5.1 Electrical requirements ....................................................................... 5-2
5.2 Environmental condition ..................................................................... 5-3
5.3 Unpacking ........................................................................................... 5-3
5.4 Space requirements............................................................................. 5-4
5.4.1 PAN versions....................................................................................5-4
5.4.2 CEPH version ...................................................................................5-5
6. INSTALLATION 6-1
6.1 Panoramic version with legs ................................................................ 6-2
6.2 Panoramic version - wall mounted (no legs)......................................... 6-7
6.3 Panoramic version with CEPH ........................................................... 6-11
6.4 Converting from “CEPH” configuration to “Prepared for CEPH”.......... 6-12
7. CHECKOUT AND ADJUSTMENTS 7-1
7.1 Power up ............................................................................................. 7-1
7.2 Set-up ................................................................................................. 7-2
7.2.1 Activation of the set-up programs .....................................................7-2
7.2.2 Modification of the values of the "Software DIP-Switches" ..................7-3
7.2.3 Non-volatile memory reset ................................................................7-7
7.2.4 Potentiometer replacement/calibration .............................................7-8
To Next Page
Loading...