GAVIN-6C Instruction Manual
- 16 -
the LCD will enter the main screen.
If the throttle stick is not at the lowest position, after turning on the power
switch, the LCD will prompt "THR is not reset!". Lower throttle stick to the
lowest position, the information will disappear and the LCD will enter the main
screen.
Turn off the transmitter:
1. Turn off the power switch, the transmitter shut down at once.
Binding
In order for the transmitter and receiver to communicate, it is essential to pair or
bind them together. When you use the R/C system first time or change a
transmitter or receiver, this procedure is necessary.
Before binding, Lower throttle to the lowest position and make sure the
transmitter is powered off. Place the transmitter and the receiver close to each
other within a distance of about one meter.
Steps:
1. Insert the bind plug into the BIND port of the receiver.
2. Turn on the receiver. The receiver's red LED will flash slowly when receiver is
ready to bind.
3. While pulling and holding the TRAINER switch of transmitter, turn on the
transmitter. The system begins to bind.
4. Once receiver's green LED stays illuminated, this indicates the receiver is
bound to the transmitter. Release the TRAINER switch.
5. Remove the bind plug from the receiver. Turn off the transmitter and receiver.
To Next Page
Loading...