2. Move both right and left sticks up and down and right to left, next set both
right and left sticks to their center position, and then press ENT key to
calibrate the sticks.
If the calibration is successful, it will prompt "Completed!", as shown in the
following figure. If failed, it will prompt "Please Retry!".
Stick Mode [Stick Mode]
This function is used to change the stick mode to meet different operating habits.
Values: MODE 1, MODE 2, MODE 3 and MODE 4. The default is MODE 1. The
right and left sticks for each mode are shown in the following figure.
To Next Page
Loading...