DETRUM GAVIN-6C - Throttle to Balance Mixing [THR►BAL Mix]

GAVIN-6C Instruction Manual
- 33 -
will adjust the aileron operation in the positive direction. The default is 100.
 FLP▶FLP: This parameter is used to set the mixing rate (percentage) from
flap channel to itself. Values: -100~100. If the value is negative, it will adjust
the flap operation in the negative direction. If the value is positive, it will adjust
the flap operation in the positive direction. The default is 100.
CAUTION:
 When using Flaperon mixing function, do not set the flap to full travel,
otherwise the aileron will be invalid.
 You can not set V-tail mixing when Flaperon mixing has already been set. In
order to enable Flaperon mixing, you need to cancel Delta mixing function
first (modify the value of Mix SW to OFF). However, it is allowed to use
Flaperon and V-tail mixing simultaneously.
Throttle to Balance Mixing [THR▶BAL Mix]
Corresponding model type: airplane, general
This function mixes the throttle operation to the aileron, rudder, and elevator.
Setting Method:
1. In the Mix Set setting interface, press UP or DOWN key to select THR▶BAL
Mix, and then press ENT key to enter the setting interface.
1/3
1. THR
0
2.THR
3.THR
0
0
RUD：
ELE：
THR BAL MIX
AIL：
2. Press UP or DOWN key to select the setting item, and then press R/+ or L/-
key to set the value of the item.
 THR▶AIL: This parameter is used to set the mixing rate (percentage) from
throttle channel to aileron channel. Values: -100~100. If the value is negative,