DETRUM GAVIN-6C - Pitch Curve [PIT Curve] (Heli only)

GAVIN-6C Instruction Manual
- 25 -
Pitch Curve [PIT Curve] (Heli only)
 NOTE: This function is available for helicopter only.
It is used to adjust pitch operation in response to throttle stick operation. The
servo position can be set independently for a maximum of 9 point positions.
You can set pitch curve for the HLD (hold), NORM (normal) and ACR (acrobatic)
flight mode of helicopter respectively.
 HLD PIT Curve (Hold Pitch Curve): It is used to adjust pitch operation in
response to throttle stick operation when the helicopter is in HLD flight mode.
 NORM PIT Curve (Normal Pitch Curve): It is used to adjust pitch operation in
response to throttle stick operation when the helicopter is in NORM flight
mode.
 ACR PIT Curve (Acrobatic Pitch Curve): It is used to adjust pitch operation in
response to throttle stick operation when the helicopter is in ACR flight mode.
 Note: The introductions for HLD, NORM, and ACR, please see Flight Mode
(Page 17).
In the Model Parameter menu, press UP or DOWN key to select PIT Curve, and
then press ENT key to enter the HLD PIT Curve setting interface.
HLD PIT Curve
ENT
EPA: +100
EXP: 0
LEVEL
RESET
1： 0.0
2： 12.5
3： 25.0
4： 37.5
5： 50.0
6： 62.5
Continue to press ENT key to enter the NORM PIT Curve and ACR THR Curve
setting interface.