GAVIN-6C Instruction Manual
- 35 -
AIL-L: This parameter is used to set the mixing rate (percentage) from aileron
channel to elevator channel when operating the aileron stick to left. Values:
-100~100. If the value is negative, it will adjust the elevator operation in the
negative direction. If the value is positive, it will adjust the elevator operation
in the positive direction. The default is 0.
AIL-R: This parameter is used to set the mixing rate (percentage) from aileron
channel to elevator channel when operating the aileron stick to right. Values:
-100~100. If the value is negative, it will adjust the elevator operation in the
negative direction. If the value is positive, it will adjust the elevator operation
in the positive direction. The default is 0.
RUD-L: This parameter is used to set the mixing rate (percentage) from
rudder channel to elevator channel when operating the rudder stick to left.
Values: -100~100. If the value is negative, it will adjust the elevator operation
in the negative direction. If the value is positive, it will adjust the elevator
operation in the positive direction. The default is 0.
RUD-R: This parameter is used to set the mixing rate (percentage) from
rudder channel to elevator channel when operating the rudder stick to right.
Values: -100~100. If the value is negative, it will adjust the elevator operation
in the negative direction. If the value is positive, it will adjust the elevator
operation in the positive direction. The default is 0.
Swash Mixing [Swash Mix] (Heli only)
NOTE: This function is available for helicopter only.
Using three servos to control the swash plate, the swash mixing function allows
coordinated control of the aileron, elevator, and pitch. This swash mixing is
essential for helicopters that incorporate CCPM (collective-cyclic pitch mixing)
system, and can make the swash plate setting easier.
1. In the Model Parameter menu, press UP or DOWN key to select Swash Mix,
and then press ENT key to enter the setting interface.
To Next Page
Loading...