DETRUM GAVIN-6C - Reset Model [Reset]

GAVIN-6C Instruction Manual
- 46 -
timer.
 DOWN Timer: This timer is enabled, and displays on the main screen as
down timer.
The default is OFF.
3. Press UP or DOWN key to select Control SW, and then press R/+ or L/- key
to set the value (timer event).
Values:
 THR: The timer will be programmed to start when the throttle is raised
above a predefined position, and pause when falling below this position. If
the Control SW is set to THR, you need to set the THR Position. Values:
-100~100. The default is -90.
 HOLD0: The timer will be programmed to start when you put the HOLD
switch on top position, and pause when you put the HOLD switch on
bottom position.
 HOLD1: The timer will be programmed to start when you put the HOLD
switch on bottom position, and pause when you put the HOLD switch on
top position.
 FMOD0: The timer will be programmed to start when you put the FMOD
switch on top position, and pause when you put the FMOD switch on
middle or bottom position.
 FMOD1: The timer will be programmed to start when you put the FMOD
switch on bottom position, and pause when you put the FMOD switch on
middle or top position.
4. Press UP or DOWN key to select Timer (min) and (sec), and then press R/+
or L/- key to set the value.
Reset Model [Reset]
This function allows you to reset all the setting of current model or all models to
default values.
Setting Method:
1. In the Model Set menu, press UP or DOWN key to select Reset.