DETRUM GAVIN-6C - Model Parameter; Servo Reverse [Rev Set]

- 19 -
Model Parameter
Before setting the model parameters, please use the Model Set function to
select a proper model.
In the main screen, press ENT key to enter the main menu, press UP or DOWN
key to select Model Parameter, and then press ENT key to enter the Model
Parameter interface.
For different model types, the model parameters are different.
AIRPLANE
HELICOPTER
MULTICOPTER
1. Rev Set
2. End Point
3. Sub Trim
4. Stick Curve
5. THR Curve
6. THR Hold
7. Mix Set
8. Servo Delay
1. Rev Set
2. End Point
3. Sub Trim
4. Stick Curve
5. THR Curve
6. PIT Curve
7. THR Hold
8. Swash Mix
9. Servo Delay
1. Rev Set
2. End Point
3. Sub Trim
4. Stick Curve
5. THR Curve
6. THR Hold
Servo Reverse [Rev Set]
This function is used to reverse the servo operating direction for each channel.
When set up a new model, you need to move the stick to check the servo
direction, to determine whether the channel direction needs to be reversed.
Setting Method:
1. In the Model Parameter menu, press UP or DOWN key to select Rev Set,
and then press ENT key to enter the setting interface.