DETRUM GAVIN-6C - Throttle Hold [THR Hold]

GAVIN-6C Instruction Manual
- 26 -
NORM PIT Curve
ENT
EPA: +100
EXP: 0
LEVEL
RESET
1： 0.0
2： 12.5
3： 25.0
4： 37.5
5： 50.0
6： 62.5
ACR PIT Curve
ENT
EPA: +100
EXP: 0
LEVEL
RESET
1： 0.0
2： 12.5
3： 25.0
4： 37.5
5： 50.0
6： 62.5
The setting method of pitch curve, please refer to Stick Curve [Stick Curve]
(Page 21).
After setting the helicopter's pitch curve, you can select the hold, normal, or
acrobatic throttle curve by using throttle hold switch (the default is HOLD) and
acrobatic flight switch (the default is FMOD).
Throttle Hold [THR Hold]
This function is for auto rotation landing by holding the throttle servo at a low
position. Using a selected switch, the throttle servo can be fixed at an optional
position, and the throttle stick will lose effect on throttle hold mode.
The HOLD switch is used for throttle hold function by default. The switch can be
modified. For details, please refer to Function Set [Func Set] (Page 40).
Setting Method:
1. In the Model Parameter menu, press UP or DOWN key to select THR Hold,
and then press R/+ or L/- key to set the value.
This parameter is used to adjust the throttle position (expressed as a
percentage and based on the throttle travel). Values: -10~50. The default is 0.
2. Open the throttle hold switch to fix the throttle servo at a preset position.