DETRUM GAVIN-6C - Servo Delay [Servo Delay] (Airplane;Heli Only)

GAVIN-6C Instruction Manual
- 37 -
 AIL Mix: This parameter is used to set the mixing rate (percentage) from
aileron to pitch when operating the aileron stick. Values:-100~100. If the value
is negative, it will adjust the pitch operation in the negative direction. If the
value is positive, it will adjust the pitch operation in the positive direction. The
default is 100.
 ELE Mix: This parameter is used to set the mixing rate (percentage) from
elevator to aileron and pitch when operating the elevator stick. Values:
-100~100. If the value is negative, it will adjust the aileron and pitch operation
in the negative direction. If the value is positive, it will adjust the aileron and
pitch operation in the positive direction. The default is 100.
 PIT Mix: This parameter is used to set the mixing rate (percentage) from
aileron to aileron and elevator when operating the aileron stick. Values:
-100~100. If the value is negative, it will adjust the aileron and elevator
operation in the negative direction. If the value is positive, it will adjust the
aileron and elevator operation in the positive direction. The default is 100.
Servo Delay [Servo Delay] (Airplane/Heli only)
 NOTE: This function is available for airplane and helicopter only.
This function allows the user to delay input from the servos, then the servos will
change at a slower rate when changing between different flying modes.
Setting Method:
1. In the Model Parameter menu, press UP or DOWN key to select Servo
Delay, and then press ENT key to enter the setting interface.
Servo Delay
1/6
1.CH 1 ：
2.CH2：
3.CH3：
0
0
0
2. Press UP or DOWN key to select the channel, and then press R/+ or L/- key
to set the delay value.
Values: 0~20. The default is 0. The larger the value is, more slowly the servo
speed changes.