DETRUM GAVIN-6C - Page 44

GAVIN-6C Instruction Manual
- 42 -
which functions and channels are to be used for instruction.
Always check operation of each control surface before each flying session. When
using the trainer function, please check the operation of both the instructor and
student transmitters.
Setting Method:
1. Use a trainer cord (optional) to connect two transmitters, and power on the
two transmitters.
2. Set the instructor transmitter for trainer operation, and choose the channels
used for instruction.
(1) In the Model Set menu, press UP or DOWN key to select Trainer Set, and
then press ENT key to enter the setting interface.
Trainer Set
1/1
1.Tainer SW：
OFF
(2) Modify the value of Trainer SW to ON by pressing R/+ key, to set this
transmitter work as trainer operation.
The setting interface is shown in the following figure.
Trainer Set
1/7
1. Trainer SW：
ON
2.AIL：
3.ELE：
ON
ON
(3) Press UP or DOWN key to select the channel, and then press R/+ or L/- key
to set the value of the channel.
Channels can be set include AIL, ELE, THR, RUD, GEAR, and AUX1.