2. Press UP or DOWN key to select the channel, and then press ENT key to
enter the setting interface.
Channels can be set include AIL, ELE, THR, RUD, GERA, and AUX1. You
can select either mode for each channel in case of loss of RF signal:
Servo Hold: Maintain the servo positions as they were immediately before
the radio signal was lost.
Fail Safe: The servos move to predefined positions in case of loss of RF
signal.
The default setting for each channel is Servo Hold. Take the aileron fail safe
setting method as an example.
3. Change the value to Fail Safe by pressing R/+ key, to activate fail safe
function.
When the fail safe function is activated, the setting interface is shown in the
following figure.
To Next Page
Loading...